Audio technica BP4025
ABOUT THE PRODUCT
The BP4025 microphone is a large diaphragm X/Y stéréo mic.
FEATURES
- Element : Fixed-charge back plate permanently polarized condenser
- Polar Pattern : X/Y Stereo
- Frequency Response : 20 - 17,000 Hz
- Open Circuit Sensitivity : -32 dB (25.1 mV) re 1V at 1 Pa
- Impedance : 170 ohms
- Maximum Input Sound Level : 145 dB SPL, 1 kHz at 1% T.H.D.; 155 dB SPL, with 10 dB pad (nominal)
- Channel Balance : < 2.5 dB
- Low Frequency Roll Off : 80 Hz, 12 dB/octave
- Switches : Flat, roll-off; 10 dB pad (nominal)
- Dynamic Range : 131 dB, 1 kHz at Max SPL
- Signal-to-Noise Ratio : 80 dB, 1 kHz at 1 Pa
- Phantom Power Requirements : 11-52V DC, 7 mA typical (both channels total)
- Weight : 269 g (9.5 oz)
- Dimensions : 186.0 mm (7.32") long, 47.6 mm (1.87") head diameter 21.0 mm (0.83") body diameter
- Output Connector : Integral 5-pin XLRM-type
- Cable : 5.0 m (16.5') long, 8 conductor, shielded, vinyl-jacketed stereo cable with 5-pin XLRF-type connector at microphone end and two 3-pin XLRM-type connectors at output end
- Accessories Included : AT8405a stand clamp for 5/8"-27 threaded stands; windscreen; soft protective pouch
- Euroguitar Reference : 971
- Polar Pattern : X/Y Stereo
- Frequency Response : 20 - 17,000 Hz
- Open Circuit Sensitivity : -32 dB (25.1 mV) re 1V at 1 Pa
- Impedance : 170 ohms
- Maximum Input Sound Level : 145 dB SPL, 1 kHz at 1% T.H.D.; 155 dB SPL, with 10 dB pad (nominal)
- Channel Balance : < 2.5 dB
- Low Frequency Roll Off : 80 Hz, 12 dB/octave
- Switches : Flat, roll-off; 10 dB pad (nominal)
- Dynamic Range : 131 dB, 1 kHz at Max SPL
- Signal-to-Noise Ratio : 80 dB, 1 kHz at 1 Pa
- Phantom Power Requirements : 11-52V DC, 7 mA typical (both channels total)
- Weight : 269 g (9.5 oz)
- Dimensions : 186.0 mm (7.32") long, 47.6 mm (1.87") head diameter 21.0 mm (0.83") body diameter
- Output Connector : Integral 5-pin XLRM-type
- Cable : 5.0 m (16.5') long, 8 conductor, shielded, vinyl-jacketed stereo cable with 5-pin XLRF-type connector at microphone end and two 3-pin XLRM-type connectors at output end
- Accessories Included : AT8405a stand clamp for 5/8"-27 threaded stands; windscreen; soft protective pouch
- Euroguitar Reference : 971
YOU WILL LIKE ALSO